How many square foot would my 12 ft smokercraft aluminum boat be?
Mar 10, 2011 by Mike | Posted in Boats & Boating
I am succeeding to be painting my boat soon and just wondering how many square foot it would be so I know how much paint to get. Can someone bring to light me a way to figure this out or if they have done it in the past give me a rough estimate. Thanks.
for ages c in depth times width (beam) but take into consideration that is square footage of flat surface buy a little bonus for height
| Mar 10, 2011
after a long time times width (beam) but take into consideration that is square footage of flat surface buy a little super for height
jim | Mar 10, 2011
Will my 1999 GMC Safari AWD V6 tow a 2001 16' Smokercraft fishing boat, 40 hp merc?
Jul 05, 2010 by banger | Posted in Boats & Boating
Depending on the appraise of the engine it should. But to be on the cautious side check with your GMC dealer. Being that you have all wheel drive there should not be no problem but remember this is a boating location and I really don't know all that much
boatguy26@sbcglobal.net | Jul 05, 2010
Redone: I'm replacing the floor in my smokercraft and need advice on type of fastener to use! Thanks..?
May 30, 2008 by canadian_gal_euchre_queen | Posted in Boats & Boating
My 20 yr old smokercraft skiff's floor rotted out. I have replaced the floor and carpet. Now, I need to replace the live well and side bench seats. There are holes where I drilled the old rivets out. They are locted mignonne much out of water level, however
The starting was alum rivets. ... that's because dissimilar metals can be a problem. There are in fact alum nuts and bolts. which will vocation fine, or purchase alum "aircraft" rivets. these are installed differently. Check tick off your
Richard C | May 30, 2008
Fishing Boats?
Aug 14, 2007 by rockinpacker | Posted in Boats & Boating
Looking at buying a new fishing sailboat, what is a good 16' fishing boat, the ones im currently considering are Crestliner,Smokercraft, Fisher and princecraft, any pro's cons , A-OK luck or bad luck?
I troll a lot, mostly clam smaller waters but
not enough info to give a reasonable answer. you should attend a boat show if in your area. also bass pro shops usually have a large selection of what you are seeking.
windybrr | Aug 14, 2007
